I have a CRS 112-8p-4s and was hoping to power some Hex s routers with it for labs
But with the stock power supply when ever i plugged in a hex s to the crs 112 I would get a low power warning so after some reading I got a Mikrotik 48V2A96W power supply but now whenever I plug in a hex s into the crs I get a high voltage warning.

I have tried the Forced on setting Auto continues the warning when I select high voltage i then get a Low Power warning again and when I select low power I get a high power warning.

Plugging a bunch of the Hex S routers into a Netgear POE switch and they all fire up no issues

So I'm stumped anyone got any suggestions?

You are using both power supplies at the same time?

No I'm not..

Put them both in their respective holes and try again.

Thank You ......... My Bad