I used WinBox and connected to the new (RB760GS) board.
Following the initial banner instructions -
Changed the admin password.
Tried to do the Update, and got the typical DNS error.
From another thread here I tried setting a manual static address for the DNS to update, still failed.
viewtopic.php?t=160591
My local DNS and gateway addresses are right, and I also added the Google DNS - all failed.
I tried to go back to the DHCP IP address, but it is all blank.
Refresh does nothing.
I restarted WinBox - and it cannot connect. Gives the default 192.168.88.1 IP, and trying to instead change it to the fixed address I tried from the forum, or the previous DHCP address, all fail.
Tried with and without the new admin password - "Cannot connect".
Did a factory reset on the box. Now I can connect,
but it is not doing DHCP.
I thought a second reset may help (?), but then now again it cannot connect.
(The reset does blink the LED light, then one beep, and a few seconds later two beeps.)
So;somewhat frustrated and stuck.
How to recover, and what are the correct initial startup instructions for the Update?
(The reset does blink the LED light, then one beep, and a few seconds later two beeps.)
So many posts on that error - and many different suggestions - but none in the initial boot-up instructions.
PS: Trying this, doesn't work - LED never starts flashing.
Resetting the RouterOS configuration
Hold this button until LED light starts flashing, release the button to reset RouterOS configuration to default.