I have some troubles with connection to wAP ac through WinBox or WebFig.
My setup:
wAP ac connected to switch CRS354, that connected to router CCR1009, that connected to WAN. PC connected to switch.
Both router and switch reset before any configuration:
Code: Select all
/system reset-configuration no-defaults=yes skip-backup=yes
Router LAN configuration:
Code: Select all
/interface bridge add name=bridge1
/interface bridge port add interface=sfp-sfpplus1 bridge=bridge1
/ip address add address=192.168.1.1/24 interface=bridge1
/ip firewall nat add chain=srcnat out-interface=combo1 action=masquerade
DHCP server setted up on router for 192.168.1.0/24.
Switch configuration:
Code: Select all
/interface bridge add name=bridge1
/interface bridge port add bridge=bridge1 interface=ether1
# and so on, add all switch interfaces to bridge1
/ip address add address=192.168.1.2/24 interface=sfp-sfpplus1
No DHCP server or client is configured on switch.
On switch in interfaces list, I see some traffic on interface where wAP ac connected.
In router, with "/ip dhcp-server lease print", I see wAP ac IP (probably, WAN IP in context of AP, not its own LAN IP) and MAC.
But, default wAP ac LAN IP is "192.168.88.1", so it is unreachable in my setup in "192.168.1.0/24" LAN.
I can connect to the wAP ac with Wi-Fi and access WebFig on "192.168.88.1". In this way, I think, it is possible to configure wAP ac for "192.168.1.0/24" network and then, probably, it will be reachable in LAN. But this is huge work, because I have a few dozens of this AP`s and doing all this work manually is annoying.
Maybe, it is possible to configure something in router or\and swtich that allows to reach this wAP ac throug LAN without any configuration through Wi-Fi?
Thanks.