Hi,
PPPOE is conected and internet detected. Masquerade is set to pppoe int. but websites are not loading. Please check the log and help me...
None or some ?but websites are not loading
As i can see in your initial export, ether1 and PPPoE are set as WAN already.if I understood, Ether 1 and pppoe wil be set as WAN?
From router is ping ok.You can post your code inside code tags, /export hide-sensitive instead of providing your whole configuration...
None or some ?but websites are not loading
Can you ping lets say 8.8.8.8 from your router and from your computer ?
Can you ping any domain names as well ?
In PPOE is MTU 1480 and on others interfaces is 1500. Is it problem?
$ ping xxx.yyy.zzz.www -s 1460 -M do
PING xxx.yyy.zzz.www (xxx.yyy.zzz.www) 1460(1488) bytes of data.
ping: local error: Message too long, mtu=1480
$ ping xxx.yyy.zzz.www -s 1460 -M dont
PING xxx.yyy.zzz.www (xxx.yyy.zzz.www) 1460(1488) bytes of data.
1468 bytes from xxx.yyy.zzz.www: icmp_seq=1 ttl=254 time=8.79 ms
I have in DHCP only dynamic client, I can not change the distance to 2. Should I really remove it and leave it without any DHCP client?In the DHCP client, set the default-route-distance to 2 or disable it.
Did you change the default masquare nat? If so, revert the changes.
One more question. What about the DNS settings?
I have set up all mentioed, and at the moment is internet in PC Ok, data goes thorough the pppoe interface. I will try few restarts and let you. I have even changed the internet detection only to WAN ports.In the DHCP client, set the default-route-distance to 2 or disable it.
Did you change the default masquare nat? If so, revert the changes.
One more question. What about the DNS settings?