Folks
My apologies for the newbie question. I own an RB962, which runs quite well, not with optimal performance because I'm using auto frequency selection, with download rates near 300mbps, though. This is the bandwidth I have with the ISP.
Last week I bought a cAP AC to improve the signal coverage on the 1st floor and replace a TP-Link repeater. Configured CAPsMAN, set both the router and the AP WLAN interfaces to CAP. The 2.4ghz is working ok. I don't even bother about speed because it's used primarily for IoT and home automation.
But I'm struggling with the 5ghz. I've tried many different channel configurations, channel extension, always setting 20MHz, and the max RX I got so far with BTest (standing 2m always from the antenna) was 227mbps, which is ok, but then it dropped to 90mbps. I was utilizing 5765/20/eCee.
Does anyone have any recommendations on channel configuration or anything else I can do in CApsMAN to improve 5ghz?
I appreciate any advise.
Cheers.