WAN1: 400mb/sec, 55.x.x.x
WAN2: 1000mb/sec 192.x.x.x
Simple load balance setup using PCC 'both addresses' across both WAN connections. No matter what I do (even disabling each WAN interface one at a time) I can't get the speed above 450/mbs. If I test each link independently by removing them from the Mikrotik, I get the expected results. Any ideas?
/ip firewall mangle
add action=accept chain=prerouting comment=Accept dst-address=55.188.40.0/24
add action=accept chain=prerouting dst-address=192.168.1.0/24
add action=accept chain=prerouting dst-address=10.10.10.0/24
add action=mark-connection chain=input comment=Input in-interface=ether1-ISP1 \
new-connection-mark=ISP1 passthrough=yes
add action=mark-connection chain=input in-interface=ether2-ISP2 \
new-connection-mark=ISP2 passthrough=yes
add action=mark-connection chain=prerouting comment="Mark Connection" \
in-interface=ether1-ISP1 new-connection-mark=ISP1 passthrough=yes
add action=mark-connection chain=prerouting in-interface=ether2-ISP2 \
new-connection-mark=ISP2 passthrough=yes
add action=mark-connection chain=prerouting comment=PCC dst-address-type=local \
in-interface=LAN new-connection-mark=ISP1 passthrough=yes \
per-connection-classifier=both-addresses:2/0
add action=mark-connection chain=prerouting dst-address-type=local \
in-interface=LAN new-connection-mark=ISP2 passthrough=yes \
per-connection-classifier=both-addresses:2/1
add action=mark-routing chain=output comment=Output connection-mark=ISP1 \
new-routing-mark=to-ISP1 passthrough=yes
add action=mark-routing chain=output connection-mark=ISP2 new-routing-mark=\
to-ISP2 passthrough=yes
add action=mark-routing chain=prerouting comment="Mark Route" connection-mark=\
ISP1 in-interface=LAN new-routing-mark=to-ISP1 passthrough=yes
add action=mark-routing chain=prerouting connection-mark=ISP2 in-interface=LAN \
new-routing-mark=to-ISP2 passthrough=yes
/ip firewall nat
add action=masquerade chain=srcnat out-interface=ether1-ISP1
add action=masquerade chain=srcnat out-interface=ether2-ISP2
[admin@MikroTik] /ip/firewall>
/ip route
add disabled=no distance=1 dst-address=0.0.0.0/0 gateway=55.188.40.1 pref-src=\
"" routing-table=main scope=30 suppress-hw-offload=no target-scope=10
add disabled=no distance=1 dst-address=0.0.0.0/0 gateway=192.168.1.254 \
pref-src="" routing-table=main scope=30 suppress-hw-offload=no \
target-scope=10
add disabled=no distance=1 dst-address=0.0.0.0/0 gateway=55.188.40.1 pref-src=\
"" routing-table=to-ISP1 scope=30 suppress-hw-offload=no target-scope=10
add disabled=no distance=1 dst-address=0.0.0.0/0 gateway=192.168.1.254 \
pref-src="" routing-table=to-ISP2 scope=30 suppress-hw-offload=no \
target-scope=10