Community discussions

MikroTik App
 
pukoid
just joined
Topic Author
Posts: 5
Joined: Thu Feb 01, 2018 1:26 pm

Routing table in 6.49

Mon Jan 24, 2022 7:06 am

Updated new RB951G to 6.49.2, reset to factory, and started to config.
When adding route: /ip route add 0.0.0.0/0 gateway=x.x.x.x pressing Tab and see suggestion to add @main to ip address - x.x.x.x@main .
Is it some lame-backported feature from v7?
Because there is neither /routing/table section not routing-table parameter in v6. Only in /ip route rule parameter "table"
 
aesmith
Member Candidate
Member Candidate
Posts: 264
Joined: Wed Mar 27, 2019 6:43 pm

Re: Routing table in 6.49

Tue Jan 25, 2022 6:58 pm

I get the same (although the syntax is actually "/ip route add dst-address=0.0.0.0/0 gateway=x.x.x.x")
But if you type a space after the gateway before pressing tab then it comes up with sensible suggestions.
 
User avatar
mrz
MikroTik Support
MikroTik Support
Posts: 7042
Joined: Wed Feb 07, 2007 12:45 pm
Location: Latvia
Contact:

Re: Routing table in 6.49

Tue Jan 25, 2022 9:03 pm

No it is not lame backported v7 feature. v6 also have VRF support where this syntax is used.

Who is online

Users browsing this forum: Ahrefs [Bot], daliusm, dervomsee, roemer and 88 guests