I have installed 7.1.3 to CRS318-16P-2S+. I tried to setup the L3HW interVLAN routing based on the website documentation. I think it doesn't work because I always got high CPU percent.
Is it possible on this device?
(I tried to enable l3hw on the ether1 also, but doesn't work...)
best regards, Gabor
Here is the export coming...
Code: Select all
/interface bridge
add ingress-filtering=no name=bridge protocol-mode=none vlan-filtering=yes
/interface vlan
add interface=bridge name=vlan10 vlan-id=10
add interface=bridge name=vlan60 vlan-id=60
/interface ethernet switch
set 0 l3-hw-offloading=yes
/interface ethernet switch port
set 0 l3-hw-offloading=no
/interface bridge port
add bridge=bridge interface=ether1 pvid=10
add bridge=bridge interface=ether2 pvid=60
add bridge=bridge interface=ether3 pvid=60
add bridge=bridge interface=ether4 pvid=60
/interface bridge vlan
add bridge=bridge tagged=bridge vlan-ids=10
add bridge=bridge tagged=bridge vlan-ids=60
/ip address
add address=10.100.64.1/24 interface=vlan60
/ip dhcp-client
add interface=vlan10