My current core network is Cisco based running MP-BGP. We have used MT routers in the past (V6.x) with limited success due to limitations around certain services not being VRF aware, but otherwise worked as expected. Now that V7 is here some of those service are now VRF aware and we are wanting to use MT routers in some locations within the network. I have a RB3011 setup as a test rig. OSPF routing is working as with all the routes I expect, LDP session is active and receiving labels and BGP is active and receiving routes for the VRFs. The issue I am running into now is I cannot pass any traffic through the VRF from one PE to another. I have a Loopback address and vlan on the same VRF with a PC and can pass traffic between them but no traffic will traverse to another PC (Same VRF) on a different PE. I can pass traffic on the global routing table from other PE's to the MT and viscera.
Anyone have ideas? Config is attached . Note: I am using a bridge interface simply due to only having the option of a single uplink to the core. The VRF in question is bw-mgmt