Okay I have a dgs1100-24 and I dont have any pvid menus as its one step up the food chain in setup or its just older, who knows..
In any case I have provided a setup I use on one of my netgear smart switches that mimicks your choices.
To give you context
FIRST PICTURE
Trunk Ports are 1,3,7,8
1 goes to capac AP smart
3 goes to Tplink AP smart
7 goes to Main Router
8 goes to Backup to main router in case ether7 port fails.........
Access Ports are 2,4,5,6
2 goes to a dumb iot device
4 goes to a dumb switch
5 goes to another dumb iot device
6 is a spare port where I can hook up my laptop (dumb device).
PICTURES2-4
These show the tagging and untagging of various VLANS assigned to the switch.
As you can see the default PVID for every port is VLAN1 UNTAGGED, since we dont change PVID for trunk ports then each trunk port should have an untagged entry.
All access ports should have NO entry for vlan1 (tagged or untagged) as the pvid entry for the specific port removes vlan1 from the equation.
The 2nd picture shows the relationships of vlan1 to the ports (default vlan)
The 3rd/4th picture show the relationships of normal VLAN that comes in on trunk port and goes out both trunk and access ports (tagged for all trunk ports and untagged for access ports)
..............
exampleQ1.JPG
q2.JPG
q3.JPG
q4.JPG
q5.JPG
You do not have the required permissions to view the files attached to this post.