Community discussions

MikroTik App
 
aoakeley
Member Candidate
Member Candidate
Topic Author
Posts: 170
Joined: Mon May 21, 2012 11:45 am

Routing Table Column in IP-Routes in Winbox default view

Mon May 09, 2022 12:45 pm

Hi,

Does anyone else think the "Routing Table" column in IP-Routes in winbox should be shown by default in v7, in the same way that the "Routing Mark" column was shown by default in v6?
It is not the end of the world to enable it each time, but I would find it nice if it was enabled by default as it was in v6.
Wondering if anyone else felt the same way?


Screenshot 2022-05-09 173931.png
You do not have the required permissions to view the files attached to this post.
 
User avatar
rextended
Forum Guru
Forum Guru
Posts: 11967
Joined: Tue Feb 25, 2014 12:49 pm
Location: Italy
Contact:

Re: Routing Table Column in IP-Routes in Winbox default view

Mon May 09, 2022 2:35 pm

You can do yourself saving the session as default session on winbox.
 
Sob
Forum Guru
Forum Guru
Posts: 9119
Joined: Mon Apr 20, 2009 9:11 pm

Re: Routing Table Column in IP-Routes in Winbox default view

Mon May 09, 2022 4:21 pm

Yes, but it should be also visible by default, because it's important piece of info, almost as destination address or gateway. It was in v6 and there's no good reason to remove it. Btw, with IPv6 in v7 it's even worse, it doesn't even show gateway by default.
 
aoakeley
Member Candidate
Member Candidate
Topic Author
Posts: 170
Joined: Mon May 21, 2012 11:45 am

Re: Routing Table Column in IP-Routes in Winbox default view

Fri May 13, 2022 2:41 am

You can do yourself saving the session as default session on winbox.
When you connect to thousands of different routers, often using different IP's, this is not practical.
 
aoakeley
Member Candidate
Member Candidate
Topic Author
Posts: 170
Joined: Mon May 21, 2012 11:45 am

Re: Routing Table Column in IP-Routes in Winbox default view

Fri May 13, 2022 2:43 am

Yes, but it should be also visible by default, because it's important piece of info, almost as destination address or gateway. It was in v6 and there's no good reason to remove it. Btw, with IPv6 in v7 it's even worse, it doesn't even show gateway by default.
Glad I am not the only one that thinks this.

Who is online

Users browsing this forum: No registered users and 14 guests