Hi
I just upgraded my rb4011 to 7.2.3 and lost my IPv6 gateway
I looked into it and there was magically 2x default routes, both identical apart from was DAd+ and the other DAv+
Any ideas where the DAv+ has come from? It says v for vpn but that makes no sense
Now I have removed the default route with DAv+ from the routing table and my IPv6 works again. Weird.
Other issue I had was post upgrade the router would not boot with the SFP installed. And when it did boot with it removed as soon as i reinserted it it flashed and strobed the LEDs for all the interfaces and the SFP activity light and communication on any interface was lost to the router.
I let it boot and sit idle for a while then rebooted it again powered it off in the process and now SFP no longer stops all the traffic and works as expected.
Other than that the new Wire Guard VPN soo much less hassle than IPSec IKE etc very good
Thanks