Hello,
I have vlans setup on my RB2011's switch by following the guide in "VLAN Example #2" here: https://wiki.mikrotik.com/wiki/Manual:I ... _Filtering
All seems to be working fine, and device on access ports get the correct addresses/connectivity from the router, but I cannot connect over Romon to this device any longer (had to configure another port not on the bridge for accessing the device directly). Is there something extra which needs configuring to get Romon working again?
This is the first device I have setup using VLANs on the switch chip rather than just using a bridge with vlan filtering activated.
Thanks!