I have a RB333 installed with about 180 feet of cable and a 28V high end regulated power supply. In 100mbit half duplex it works generally but we sometimes loose the eth link and have to reboot it. If we enable full duplex about 15% of pings are dropped.
The radio we used to have in the role was non MT and worked fine at 100mbit full duplex.
Just to be sure we replaced the cable, ethernet surge supressor and POE today. The problem remains.
It is plugged into a high end HP managed switch and we have tried using alternate ports too.
Are there are known bugs with the eth code on the RB333?