Hello
I have the following scenario:
CRS312-4C+8XG, RouterOS 7.3.1
Linux host (Debian) connected with 2x 10G with the following config
auto ens1f0
iface ens1f0 inet manual
auto ens1f1
iface ens1f1 inet manual
auto bond0
iface bond0 inet dhcp
bond-slaves ens1f1,ens1f0
bond-mode 802.3ad
bond-miimon 100
dozens of VLANs
what I am trying to do is to aggregate two 10G ports together into a 20G port.
LACP is whats needed here and I use this successfully on my routers.
However on the Mikrotik Switching devices I have problems to set this up.
What I tried is to create a bonding interface with 802.3ad which includes the two physical ports towards the linux box. If you assign ip on that port, you can talk to the linux box normally but then its isolated from the rest of the ports.
So I put this bondig port into the bridge as port. But then it can talk to nothing. DHCP doesnt work neither.
Using only a single port and put it into the bridge, without bonding, works perfect.
But putting a 802.3ad bond into the bridge doesnt. I don't understand why.
Same problem arrives when I want to use a uplink to my 100G switch with 2x10G
Any hints?