I been going thru a lot of posts to try to get an idea but I feel like i cant move forward without some direction.
# mar/27/1970 14:51:45 by RouterOS 7.2.3
# software id = TRJD-QWV4
#
# model = RB911G-5HPacD
# serial number =
/interface bridge
add admin-mac=2C:C8:1B:AE:6B:B3 auto-mac=no comment=defconf name=bridge
/interface wireless
set [ find default-name=wlan1 ] adaptive-noise-immunity=ap-and-client-mode \
amsdu-limit=2048 amsdu-threshold=2048 antenna-gain=30 band=5ghz-a/n/ac \
channel-width=20/40/80mhz-eCee country=turkey disabled=no frequency=5640 \
frequency-mode=superchannel hw-retries=3 mode=ap-bridge nv2-cell-radius=\
23 nv2-downlink-ratio=60 nv2-security=enabled rx-chains=0,1 ssid=\
Invul_WIFI tx-chains=0,1 wireless-protocol=nv2
/interface wireless nstreme
set wlan1 disable-csma=yes enable-polling=no
/interface list
add name=WAN
add name=LAN
/interface lte apn
set [ find default=yes ] ip-type=ipv4 use-network-apn=no
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa-psk,wpa2-psk eap-methods="" \
mode=dynamic-keys supplicant-identity=MikroTik
/routing bgp template
set default disabled=no output.network=bgp-networks
/routing ospf instance
add disabled=no name=default-v2
/routing ospf area
add disabled=yes instance=default-v2 name=backbone-v2
/interface bridge port
add bridge=bridge comment=defconf ingress-filtering=no interface=ether1
add bridge=bridge comment=defconf ingress-filtering=no interface=wlan1
/ip settings
set max-neighbor-entries=8192
/ipv6 settings
set disable-ipv6=yes max-neighbor-entries=8192
/interface detect-internet
set detect-interface-list=all
/interface list member
add interface=ether1 list=WAN
add interface=wlan1 list=LAN
/interface ovpn-server server
set auth=sha1,md5
/ip address
add address=192.168.1.23 disabled=yes interface=wlan1 network=192.168.1.0
add address=192.168.1.221/24 interface=bridge network=192.168.1.0
/ip dhcp-client
add comment=defconf disabled=yes interface=bridge
/ip dns static
add address=159.148.172.226 name=upgrade.mikrotik.com
/ip route
add disabled=no dst-address=0.0.0.0/0 gateway=192.168.1.1
/system identity
set name=INVULBASE
My bridge is in the city center hosting my 1000mbps fiber connection. Distance is 21km at sea level while my receiver is 650 meter higher altitude
Initially i was able to reach to 120-140mbps which is something I can live with. At the moment my speed is in range of 40mbps and even tho i keep playing with settings i cant seem to improve it.
Could you give me an idea if any of my settings might be causing conflict between them.
I would appreciate any feedback
Thank you!