Community discussions

MikroTik App
 
dcasamajo
just joined
Topic Author
Posts: 1
Joined: Thu Aug 04, 2022 10:25 am

KNOT RB924I with nanoSIM to send SMS

Fri Aug 05, 2022 9:07 am

Hello,
We have purchased a Knot RB924I 2nd BT5&BG77 and triying to configure the nanoSIM to send SMS's.
The solution does not work.
The fist question is the introduction of the nanoSIM. We put it with conections up & the notch right.
The second is the procedure/steps to make it work.
Thanks & regards.
 
denissMT
MikroTik Support
MikroTik Support
Posts: 49
Joined: Wed May 26, 2021 12:00 pm

Re: KNOT RB924I with nanoSIM to send SMS

Wed Sep 07, 2022 12:11 pm

First of all, make sure SMS is supported by your ISP.
Secondly, make sure that the "port" is not used by the PPP out interface:
___
[admin@Blabla] > tool sms send modem phone-number="+xxxxx" message="message" channel=2
failure: port's channel is already in use
___
If you see that the port is already in use, you need to free it. Try disabling and enabling the PPP interface back but!! do not send any traffic yet. Make sure that the "modem" port under "System>Ports" is not "Used by" anything.

Then, enable GSM debugging to see which AT commands are sent:
https://help.mikrotik.com/docs/display/ ... -Debugging

When port is not used by anything, you can issue the command like:
___
[admin@Blabla] > tool sms send modem phone-number="+XXXXXXXX" message="message" channel=2
___

if you still have issues, we advise creating a support ticket in our system:
https://mikrotik.com/support

PS:
The sim slot itself indicates how the nanoSIM card should be installed:
https://i.mt.lv/cdn/rb_images/2035_hi_res.png
"cut" corner to the right

Who is online

Users browsing this forum: ivicask, RobertsN and 14 guests