Hi!
I have a hAP ac2 which I would like to use as following:
- access-point to my lan;
- lan connected to port 1 (internet/POE in) because of POE;
- Internet from the factory would be connected to port2 (instead of the usual wan port);
- Internet from the factory would be accessed as DHCP client;
- I would like to retain the web setup interface for later access to it (with an assigned IP);
- I would like to have DHCP active on lan (with a smaller pool);
- Firewall and such security stuff I would like to retain;
In short I'd like to have port 2 as wan and port 1 as lan, otherwise I'll keep all routing and DHCP functionality!
Up until now:
- If I simply turn on bridge mode, DHCP remains on with 192.168.178.x IP addresses - not OK as I have an other IP range mandatory because some industrial equipment;
- If I change the OP of the hAPac2 before I switch to bridge mode, then I lose the webfig interface (can not connect anymore) - obviously not good for future)
- If I kill all the firewall rules then everything works, but no routing and no security...
I don't want you to feed me with spoon but I'm getting crazy. I taught that by replacing in Bridge»Ports»ether2 with ether1 and by adding in Interfaces»Interface list»ether2 to WAN my problem would have been solved, but unfortunately not...
Running 6.45.9