I am trying to configure the (2) QSFP+ ports to support a 40G twinax (aka DAC) cable. By default, they seem to be configured to support a 4 x 10G break-out cable
Where do I find instructions on doing this?
I am consulting the following:
https://help.mikrotik.com/docs/display/ ... tswitching
https://wiki.mikrotik.com/wiki/Manual:S ... p_Features
But I don't see any discussion of an /interface/ethernet xyz command which even mentions the "qsfpplus1" and "qsfpplus2" ports
None of these options seem to allow me to change the port from "split into (4) 10G channels" to "present a single 40G QSFP+ port"
[admin@MikroTik] /interface ethernet>
.. -- go up to interface
blink -- Generate traffic to blink leds
cable-test --
comment -- Set comment for items
disable -- Disable items
edit --
enable -- Enable items
export -- Print or save an export script that can be used to restore configurati
on
find -- Find items by value
get -- Gets value of item's property
monitor -- Monitor interface status
print -- Print values of item properties
reset-counters --
reset-mac-address --
set -- Change item properties
switch --
unset --
[admin@MikroTik] /interface ethernet> >
Suggestions?
--sk
Stuart Kendrick