Community discussions

MikroTik App
 
KimShaw
just joined
Topic Author
Posts: 1
Joined: Fri Nov 11, 2022 6:56 pm

RB5009UPr+S+IN having POE-in issues

Fri Nov 11, 2022 7:09 pm

I have RB5009UPr wont accepts PoE-in. Its connected to cisco 3750x. I know cisco works well as it's powering up 8 cameras and it can power up to 24 devices.
Wondering if there any setting needed to be enabled on RB5009 as currently PoE Out is set to auto under all infaces?
 
Miguelin
just joined
Posts: 20
Joined: Thu Aug 27, 2020 10:08 am

Re: RB5009UPr+S+IN having POE-in issues

Sun Feb 19, 2023 6:08 pm

Same problem.

I noticed only eth1 enables PoE-in. All other interfaces (eth2 to eth8) don´t boot up the router.

Is there anyone using it?

Regards
 
ppireff
just joined
Posts: 2
Joined: Fri Feb 17, 2023 10:19 pm
Location: Bulgaria/Sofia

Re: RB5009UPr+S+IN having POE-in issues

Sun Feb 19, 2023 9:44 pm

POE-In is supported only on ether1. The other ports are not hardware wired for it to work. There is a discussion on Reddit about the misleading marketing from MikroTik.
 
liviu2004
Frequent Visitor
Frequent Visitor
Posts: 60
Joined: Tue Jul 01, 2008 10:22 pm
Location: Rotterdam

Re: RB5009UPr+S+IN having POE-in issues

Sun Feb 19, 2023 10:44 pm

PoE in 802.3af/at (ether1), Mode B (ether2-ether8)
 
Miguelin
just joined
Posts: 20
Joined: Thu Aug 27, 2020 10:08 am

Re: RB5009UPr+S+IN having POE-in issues

Mon Feb 20, 2023 12:18 am

PoE in 802.3af/at (ether1), Mode B (ether2-ether8)
Mode B is pre-standard? I have an Aruba switch which supports 802.3af/at and 802.3af/at + Pre-standard

Who is online

Users browsing this forum: Fogga and 11 guests