But now that it's out in the field, that's not what we're seeing. We had to replace an AP, and its connected station reconnected to the new AP, BUT. It reconnected to both radios, BUT all traffic was now being sent over the (slower) 5GHz radio. It didn't cut back over to the wlan60 channels until we physically turned off the wlan1 radio on the AP.
The configurations are quite fairly simple, so it's easily possible that something important got missed. How can we get the traffic to be prioritized onto the wlan60-1 radio when that link is connected and up?
AP config:
Code: Select all
/interface bridge
add admin-mac=XX:XX:XX:XX:XX:XX auto-mac=no comment=defconf name=bridge
/interface wireless
set [ find default-name=wlan1 ] band=5ghz-a/n/ac country=canada disabled=no frequency=auto installation=outdoor mode=ap-bridge ssid=SSID wireless-protocol=802.11
/interface w60g
set [ find ] disabled=no isolate-stations=no name=wlan60-1 password=PASSWORD put-stations-in-bridge=bridge region=no-region-set ssid=SSID
/interface w60g station
add mac-address=XX:XX:XX:XX:XX:XX name=wlan60-station-1 parent=wlan60-1 remote-address=XX:XX:XX:XX:XX:XX
/interface vlan
add interface=bridge name=VLAN vlan-id=NNN
/interface list
add name=WAN
add name=LAN
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa2-psk eap-methods="" mode=dynamic-keys supplicant-identity=MikroTik wpa2-pre-shared-key=PASSWORD
/port
set 0 name=gps
/interface bridge port
add bridge=bridge comment=defconf interface=ether1
add bridge=bridge comment=defconf interface=wlan1
/interface list member
add interface=ether1 list=WAN
add interface=wlan1 list=LAN
add interface=wlan60-1 list=LAN
/ip address
add address=XX.XX.XX.2/24 comment=defconf interface=VLAN network=XX.XX.XX.0
/ip route
add distance=1 gateway=XX.XX.XX.1
/system gps
set port=gps
Station config:
Code: Select all
/interface bridge
add admin-mac=XX:XX:XX:XX:XX:XX auto-mac=no comment=defconf name=bridge
/interface wireless
set [ find default-name=wlan1 ] band=5ghz-a/n/ac channel-width=20/40/80mhz-XXXX country=canada disabled=no frequency=auto installation=outdoor mode=station-bridge ssid=SSID
/interface w60g
set [ find ] disabled=no isolate-stations=no mode=station-bridge name=wlan60-1 password=PASSWORD put-stations-in-bridge=bridge region=no-region-set ssid=SSID
/interface vlan
add interface=bridge name=VLAN vlan-id=NNN
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa2-psk eap-methods="" mode=dynamic-keys supplicant-identity=MikroTik wpa2-pre-shared-key=PASSWORD
/port
set 0 name=gps
/interface bridge port
add bridge=bridge comment=defconf interface=ether1
add bridge=bridge interface=all
/ip address
add address=XX.XX.XX.3/24 comment=defconf interface=VLAN network=XX.XX.XX.0
/ip route
add distance=1 gateway=XX.XX.XX.1