Hi,
So im very new to this. I have basic knowledge about networking.
I have a problem with my new MikroTik HAP AX3.
Currently i have a Netgear RAX40 router this router has a dedicated WAN port.
In that WAN port i have connected the UTP CAT6 cable to the Ziggo Gigabox modem, this modem is in bridged mode.
Let's call that cable: WAN Yellow Cable
If i connect my laptop with a WHITE UTP CAT6 cable to port01 from the Netgear RAX30 router i have internet.
So the Ziggo modem is giving me a IP address. (DHCP)
Now when i remove that WAN Yellow Cable en connect it to PORT01 in the MikroTik router it doesnt get a IP address.
Better yet it doesnt see any traffic (no RX/TX data) see screenshot interfaces.png.
So the same cable is being used, works on Netgear not on MikroTik.
I know that sometimes the modem needs a reboot before handing out the IP to a new device so i restarted the modem and after that i rebooted de MikroTik HAP AX3. (just in case)
On other interfaces it shows traffic e.g: ether2 is my laptop. see screenshot interfaces.png.
Now im not sure if i need to follow the next steps because there is no traffic on that interface/port... (i did it anyway no luck)
I have followed this official help page https://help.mikrotik.com/docs/display/ ... figuration
01.) Just to be sure i have removed the default config with this command: /system reset-configuration no-defaults=yes skip-backup=yes
02.) After the reset and reboot, RouterOS does not have a config, great!
03.) Then i followed the rest of the steps:
Configuring IP Access with the commands on the help page.
DHCP Setup -> /ip dhcp-client add disabled=no interface=PORT01-Internet -> see screenshot interfaces.png
DNS config -> ISP provided settings and 8.8.8.8
04.) Still no traffic.
05.) When i do a cable test on PORT01-Internet it says no link. See screenshot NoLink.png
06.) The software version is: 7.6 (stable). see screenshot version.png.
I don't know what to do now, i hope somebody can help me.