Hello
I remember a pratice that I had in the past in the 5.x and 6.x releases.
After a lot of upgrades I was used to reset to factory default the device and then past back the configuration (previously exported compact).
This was a kind of refresh of the device. I did that on the POP routers or very important routers.
I read in the forum that is nice to netinstall a device after upgrade to v7 to avoid any issues from the previous configuration.
I have met the issue of upgrading from the v6 to v7, and in case of downgrade, I got back the v6 configuration.
The question is:
Since it is not possibile to netinstall a remote router in a remote location, it sufficent to reset to factory default (no default conf), and paste back the configuration, to refresh the unit?
I can reach in L2 the units in my pop, so that is easy for me to to reset and then mac-telnet.
What is your opinion?
Thank you