Fri Jan 27, 2023 10:20 am
The static routes on Router 1 and Router 2 would look like this:
Router 1:
/ip route add dst-address=192.168.101.0/24 gateway=192.168.100.1
Router 2:
/ip route add dst-address=192.168.100.0/24 gateway=192.168.101.1
In the above example, the static routes are added using the "ip route add" command and the destination network is specified using the "dst-address" parameter. The gateway parameter is used to specify the next hop IP address, which in this case is the IP address of the EOIP interface on the other router.
In terms of source or destination NAT, you do not need to use NAT in this case, as long as the routing is configured correctly. The EoIP Tunnel creates a virtual interface on both routers and it can be used as a gateway.
It's always a good idea to test the communication between the two LANs after configuring the routing, using the ping command or a similar tool, to ensure that the traffic is flowing as expected.