Hello,
I'm having some difficulties in connecting an industrial controller with ethernet and is proper unadjustable software.
Industrial Controller -> connected direct with ethernet cable to PC IP:192.168.1.39 = all is running perfectly
If I plug-in the Industrial controller to the Mikrotik RB2011UIAS I does seem to find the controller with:
IP:192.168.1.55 and MAC 37:80:E1:00:00:00 (strange MAC??)
But the software fails to connect...
If i log the connection via TCPview it seems the software always look for sync at 192.168.1.55 port 6155 for 5-10sec
Anyone can shed some light, as my network knowledge on this level is rather limited.
The MikroTik is operational in AP-Bridge mode, so the simpelest setup.
Big thanks in advance!