IP Neighbours list is fine to identify all connected neighbors, but Mikrotik displays VLAN or VRRP under the interface column and not the actual ethernet port to which particular device is attached as with 7.8.
I might be missing something here but also NetScout attached to the ethernet ports behaves in different manner and doesn't always display the actual port... though sometimes it does and I was not able to figure out in which circumstances this behavior changes.
For neighboring other Mikrotik devices such as CAPs attached to CRS354, their uplink port is displayed which is normally always "ether1" instead of CRS354 neighbour list displaying the actual CRS354 switch port to which CAP device is attached.
I can survive discovering through ARP, ROMON or even port disabling/enabling, but wonder if there is any better way for this?
All three CDP/NDP/LLDP are on.