Hello
HAP AX3
config built from scratch
everything in a bridge except eth1
this is an extract of the conf, regarding only the wave2 part.
/interface wifiwave2 security
add authentication-types=wpa-psk,wpa2-psk management-protection=allowed name=protetto passphrase=xxxzzzyyyy wps=push-button
/interface wifiwave2 configuration
add channel.skip-dfs-channels=10min-cac country=Italy disabled=no name=cfg1 security=protetto
add channel.skip-dfs-channels=disabled country=Italy disabled=no name=cfg2 security=protetto
/interface wifiwave2
set [ find default-name=wifi1 ] configuration=cfg1 configuration.mode=ap .ssid=SSID disabled=no
set [ find default-name=wifi2 ] configuration=cfg2 configuration.mode=ap .ssid=SSID disabled=no
I have read the manual, I have understood that the defaults settings choose the widest channel and are good.
I have one customer that complaints that the wifi disconnects...
I had before a single configuration (cfg1) with DFS channel set to 10min-cac
I created a new one (cfg2) for the 2.4g with DFS set to all to avoid any disconnections (there are not dfs in the 2.4).
Is that correct?
I am using 7.8