Looks fine, how are you testing the speed? You should test through the devices, not on the devices. And post the config if you still have issues.
Great, thank you.
Regarding the speed: I was just quoting the tx and rx shown in my screeshot.
I have an AP connected to cube1 and cube2 is on the same lan as a hex, so I ran BW test from the AP to the hex. Results are about 95Mbps both tx and rx.
When run from the AP to cube1, results are about the same.
So then I thought: That's strange.
Sure enough, all the wired connections are at 100mbps.
Both Cube1 and wAP-AC are wired into a CSS106-1G-4P-1S. I don't know why.
Tried rebooting the CSS106 -- didn't help.
Tried disabling auto-negotiate (link speed) on the wAP and rebooting -- now the wAP won't connect to the CSS106. Tried disabling auto-negotiate on the CSS106, but that didn't allow the connection to be made.
I could connect Cube1 directly to the wAP, but I was hoping I wouldn't have to do that because it would mean getting a very high ladder or the tractor bucket out again. But, now that the wAP can't connect, looks like it's tractor time.