Hi I have a situation where I need to have 2 ports on separate networks but want a VlAN for each network that would go to the unifi AP as I want SSIDs for those networks,
Example
port 2 192.168.1.1/24 main lan with trunk port for vlans and unifi AP
port 3 192.168.10.1/24 and a vlan that goes to the ssid 3 (example vlan 10)
port 4 192.168.11.1/24 and a vlan that goes to the ssid 2 (example vlan 11)

Any help on how to do this? or a better plan ?as I might be going about this wrong? I tried to put the ports 3 and 4 on a VLAN while trunking to port 2 for the AP but couldn't do it in ROS.

Thanks A LOT for any ideas

Regards


btw any idea why in the switch menu I do not have VLAN tab?

RB4011, even though it's got 2 switch chips, can't be configured directly with switch chip menus. Instead one has to configure bridge ... on ROS v7.1 and later, bridge is offloaded to HW. So use this tutorial as inspiration.

So far there's a bug, affecting HW offloaded VLAN traffic on RB4011: if a VLAN spans both switch chips (i.e. both ports ether1-5 and ether6-10), then bridge has to be tagged member even if device doesn't interact with that VLAN on IP level (read: even if RB4011 only switches traffic between ether ports).

RB4011, even though it's got 2 switch chips, can't be configured directly with switch chip menus. Instead one has to configure bridge ... on ROS v7.1 and later, bridge is offloaded to HW. So use this tutorial as inspiration.

So far there's a bug, affecting HW offloaded VLAN traffic on RB4011: if a VLAN spans both switch chips (i.e. both ports ether1-5 and ether6-10), then bridge has to be tagged member even if device doesn't interact with that VLAN on IP level (read: even if RB4011 only switches traffic between ether ports).

Thanks a lot