Mon Jun 05, 2023 1:50 pm
True repeater mode is not possible (no 4-way address mode in wifiwave2) but something can be done IF you can accept another NAT layer.
So it depends on what you want to use it for.
Default config.
Remove wif1 from bridge.
Set wifi on AX Lite to station mode and connect to AP.
DHCP client on wifi1 (it should get an IP from the router upstream)
Add ether1 port to bridge.
Move ether1 from WAN list to LAN
Move wifi1 from LAN to WAN.
And then you have following situation:
- access to network and internet for wired devices connected to AX Lite
- devices on AX Lite are not accessible from previous network
- devices connected to AX Lite can access devices on previous network