Hi!

I have made site-to-site between 2 routers on different wan locations. both have public IP.

The traffic is being seen on firewall rule from office 1, but no traffic from office 2? Wierd.


I use 0.0.0.0/0 for "allowed IP" from both sites, but I can't ping och get connections to devices between the lans.(I use VLAN on both sites)

I have made routes to local ip and used the WG adress as gateway.

Is there a problem when using it with vlan?

Is there a problem when using it with vlan?

no problems, 3 sites are connected via wireguard dual stack.

solved The problem was the Public key had been changed by itself for some reason?!...edit them back and everything worked like a charm

changed by itself for some reason

Quick, get rid of your MT device, clearly its possessed by an evil spirit.

Hi!
I have made site-to-site between 2 routers on different wan locations. both have public IP.
The traffic is being seen on firewall rule from office 1, but no traffic from office 2? Wierd

I use 0.0.0.0/0 for "allowed IP" from both sites, but I can't ping och get connections to devices between the lans.(I use VLAN on both sites)

I have made routes to local ip and used the WG adress as gateway.
Is there a problem when using it with vlan?

Be careful if you add any additional remote users to the config as then it will not necessarily work properly!!!