Hi
I'm new here
Have a LHGG lte6
downloaded winbox and followed first time config instructions to reset configuration on router.
reboot
now I can see the Mikrotik router on winbox but every time I try to login I get error
ERR: Could not connect, Macconnection syn timeout
please help and I'm not that it savvy of you could avoid using abbreviations that would really be of help to me
thanks in advance

Do you receive an IP address in the 192.168.188.X range from the LHGG when you connect your PC or Laptop to it ?

Do you receive an IP address in the 192.168.188.X range from the LHGG when you connect your PC or Laptop to it ?

Hi
Yes originally i could log into the router interface and could ping to that adress
Now i cant log in or ping to it however the router still shows on winbox neighbours
I was literally about to set up routing so i could get internet by following the first time setup instructions

I fear i have totally deleted the os on the router as I can see the Mac address but the ip address is now 0.0.0.0

I fear i have totally deleted the os on the router

Naah, don't worry , it is nearly impossible to delete the RoS (if not via hardware).

Normally you can reset the device and it will (should) be exactly in the same condition you received it.

The reset procedure is easy enough, though you might need to try it a few times as the exact timing (when to press and when to release the reset button) can be tricky..

https://help.mikrotik.com/docs/spaces/R ... set+Button

And if that doesn't solve your problem then you can Netinstall ROS onto your device.

Thanks, I'll give this a go and report back

I fear i have totally deleted the os on the router

Naah, don't worry , it is nearly impossible to delete the RoS (if not via hardware).

Normally you can reset the device and it will (should) be exactly in the same condition you received it.

The reset procedure is easy enough, though you might need to try it a few times as the exact timing (when to press and when to release the reset button) can be tricky..

https://help.mikrotik.com/docs/spaces/R ... set+Button