Community discussions

MUM Europe 2020
 
wireless12
Member Candidate
Member Candidate
Topic Author
Posts: 295
Joined: Fri Aug 31, 2007 10:49 am

will this method reduce or eliminate the interference

Mon May 25, 2009 12:49 pm

hii all.

when we make a base station using 2.4 GHz, we have to face lot of difficulties due to extensive interfence in 2.4 GHz and it also hav only 3 non overlaping channels. some time its very hard to run our network in 2.4 GHz.

But when we see in wireless setting we find 2 GHz-10MHz and 2 GHz-5Mhz aslo,Now my question is if we starting using these two band instead of 2.4 GHz only. can we come out with good results becuase when we do a scan we dont find any network on these band...

will these band will remain uneffected of interfernce by huge number of 2.4 GHz (default & traditional Band)networks in that area.. the client CPE is also a mikrotik gear.

thxxx..
 
wireless12
Member Candidate
Member Candidate
Topic Author
Posts: 295
Joined: Fri Aug 31, 2007 10:49 am

Re: will this method reduce or eliminate the interference

Mon May 25, 2009 2:05 pm

no ideas...?
 
wireless12
Member Candidate
Member Candidate
Topic Author
Posts: 295
Joined: Fri Aug 31, 2007 10:49 am

Re: will this method reduce or eliminate the interference

Tue May 26, 2009 12:35 pm

heyyyyyyyyyyy....whts up? is this is so much tough question.?
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 24323
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

Re: will this method reduce or eliminate the interference

Tue May 26, 2009 12:39 pm

no, this is not related to that. interference can still come on this channel, it doesn't mean you will see it in scan list. interference can also come from non-wifi devices. to avoid interference use a different frequency. the frequency bandwidth (5 or 10mhz) doesn't matter so much
No answer to your question? How to write posts

Who is online

Users browsing this forum: No registered users and 34 guests