I'm sure, that the installation starts sucessfully, but I don't see any text output on the minicom terminal and even in the "virsh console mikrotik43" command. The virsh command ends with "Escape character is ^]" and the console hangs up until I give CTRL+].
Code: Select all
virt-install --connect qemu:///system -n mikrotik43 -f ~/mikrotik43.qcow2 -s 30 -r 70 --noautoconsole --os-type other --os-variant generic --accelerate --network=bridge:br0 --hvm --cdrom=/root/mikrotik-4.3.iso --nographics
When I give "virt-install ... --vnc", the output on my desktop (using virt-manager linux program) is fine and I can successfully complete the installation and then even normally connect via minicom or "virsh console mikrotik43". This works perfectly.
But I want to install the mikrotik ros via text console and I don't want to use vnc. What arguments should I pass to the virt-install to run the installation in text mode? How can I do that? Or everyone uses only vnc??? The discussions on the internet said "use vnc" or "redirect the guest output to serial port" - is this possible in mikrotik installation? How?
Thank you, Tomas