while 2.4 Ghz is getting crowded day by day, its very difficult to mange wireless ISP, scanning shows 100's of networks..result is poor services to the coustomers.
so i hav decided to use 5.8 Ghz to deliver internet to my main & certain big coustomers.
But i m confused in planning it. though i m running a 2.4 Ghz wireless ISP for 4-5 years.
i hav decided to 4 5.8 GHz secotrs 90 degree for 360 deg coverage.
i will use 411AH with XR5 with each sector.
i will use 411 wityh R52 at client side.
clients are as near as 500 mtrs and as far as 10 km frm my MAST.
how shd i configure RB411AH which is hanged with each sector intially i will allow 20 users per sector.
how shd i configure client Side. for optimal results
shd i use Nstream in my network, how to configure my AP and my client CPE to fit in Nstream
till now i use to configure my side as simple AP-bridge and i just hang a very low cost CPE and configure it as client mode to connect to my AP-Bridge.(2.4 GHz band)
plz suggest me how to bulit a smooth and a powerful 5.8 Ghz which ROS version i shd use for Nstream bec there hav been a lot of discussion of poor performance of Nstream in ROS 4xx .