http://forum.mikrotik.com/viewtopic.php?f=1&t=48789, i hope it will be there on next release.so sad.... Hopefully next release!no dhcp6-pd
Hi Janisk.and considering release - you should definitely use 5.5 if you are using webfig - encryption of session even over http, and login page changed solving a lot of login problems.
Thanks for confirming this as a known bug. I tried swapping out a RB493AH with a 493G and ran into this. I'm glad it wasn't just me.this is a known problem on RB493G, you can rename the ports back to what you want, only the names have changed.
It happened to me on a rb411 and a 433 as well... not a problem, just to report....this is a known problem on RB493G, you can rename the ports back to what you want, only the names have changed.
Set your simple queue to specific interface, not to 'all', and this error will disapear.
Torch tool can monitor one interface, not all, at the same time in one window.
I've made some test with ROS 5.5 installed on RB750, RB433AH and RB450G.Src. Address always be "0.0.0.0/" and giving same error.
I am not able to reproduce this problem. What information is shown after?firmware After reboot not upgraded !!!
/system routerboard upgrade /system routerboard print
/system routerboard upgrade
/system routerboard print
I'm use this setting and mrtg cannot graph simple-queue traffic no morethis should work with 5.5Reguarding bridge Filters without conn track ??
/interface bridge settings set use-ip-firewall=yes use-ip-firewall-for-pppoe=no use-ip-firewall-for-vlan=yes
/interface bridge settings set use-ip-firewall=yes use-ip-firewall-for-pppoe=no use-ip-firewall-for-vlan=no
Maybe if you tell us what it is the rb1100 has to perform some can give an answer.Here is a simple question.
Does ROS 4.17 Run stable on RB1100?
Does it have any known problems in this configuration? If yes, what are they?
I'm on 5.2 and it's terrible, but looking forward it doesn't look any better. 4.17 is stable on everything we have, but I had heard it had problems on RB1100 boards.
One big issue i experienced with 4.X was when you try to reboot (4.X) it shuts down ? http://forum.mikrotik.com/viewtopic.php?f=7&t=47906This is why I avoid asking simple questions here when I can't get simple answers.
It is my main gateway, Queues, OSPF, NAT, Firewall, DNS, Tunnels... In short, everything except metarouter, usermamager, dude server, etc.
My problem is simple, 5.2 is a disaster and so far none of the 5.x releases have been stable. I'm sick of working with BETA quality "final" firmwares. 4.17 is rock solid on everything else we use, But the RB1100 are different with 4.x firmware.
So again we have gone nowhere and I ask my original question. Does RB1100 work with 4.17 or does it have known problems?
Perhaps now you list the problems and I will say if they fit my application
+1As fewi said ......Rudy's question is very valid, though. It depends on the technologies you use. Simple questions in complex scenarios don't get simple answers, they get wrong answers.