just to ask MikroTIK team why the default config of OmniTIK is same as on RB750 (cannot access ROS via ether1 because no neighbor and ip on this port and firewall rules block access) ?!
That's don't make any sense because in RB750 case you have router on the desk and it's easy to put lan cable in any of 5 ports and access ROS. When you install OmniTIK on top of the building and climb down to setup ROS via ether1, you can't do that...?! Sometimes is really hard to setup routers near them, or not ?
In first peaces of OmniTIK (ROS was 5.2) it was "normal" config, just like on other boards, except RB750.
Am I right about this or I missed something ?