Hi

I configured my Mikrotik router to connect pptp vpn client and the provider is hide my ass for the vpn, I have a voip ata adapter connected to my mikrotik port 2 however I do not want my voip traffic to be managed by the vpn client I want it to be connected to my isp wha twould be the settings I would need to do this?

Is there an option where you can specify what kind of traffic will go through Hide my ass?

Hi,

My RB gateway ip is 192.168.88.1

My Ata Voip Adapter 192.168.88.177

My ata voip adapter is connected into ethernet port 2 of my routerboard.

What I need is my ata voip adapter to connect/register with my real public wan ip and not the vpn I setup in the RB, I just want my computers and other devices to connect to the vpn.

What rule do I setup so my ATA Voip adapter connects to my real public ip and not the vpn?

What rule do I setup so my ATA Voip adapter connects to my real public ip and not the vpn?

ros code

/ ip firewall mangle add chain=prerouting action=mark-routing new-routing-mark=tunnel passthrough=no src-address=!192.168.88.177

Try adding the above routing mark. The exclamation mark is used on purpose.

Then replace your dynamic VPN route in IP>ROUTES with a static route to your VPN gateway and set the routing mark, like this: