- Which interface do I set the NAT masquerade rule, ether1-gateway or pppoe-out1? (I have set it on pppoe-out1 since this is the WAN interface)
- In my routes table I have two automatic 0.0.0.0 routes populated once pppoe-out1 authenticates with my ISP. One corresponding to ether1-gateway and the other to pppoe-out1. However the ether1-gateway route is highlighted blue. Firstly, is it correct to have two default routes? Secondly, why is ether1-gateway blue?
- Last, I am unable to ping the V120 from my LAN. Ping requests are timing out. Can you suspect why?
PS: I would be interested to hear of anybody else's experiences with the Draytek V120. Mine runs quite warm and there's minimal traffic/load on the modem.