Wed Mar 25, 2015 12:15 pm
I check all links/duplex, and is correct.
If I put a RB2011 before, so, RB2011 has the main input optic cable and after connect a RJ45 from RB2011 to CRS212 master-port (with SFP RJ45 module) then all works fine with no packet loss.
Why if I put a RB2011 before and connect CRS2112 with RJ45 all works fine?
What is the difference between RB2011 and CRS212 with the same SFP module??
I try several SFP modules, and the same module that works in RB2011 fine, lose packets in CRS212
The config in CRS212 not affect, however is (SFP1 and SFP2 are uplinks):
/interface ethernet
set [ find default-name=ether1 ] name=ether1-master-local
set [ find default-name=sfp1 ] master-port=ether1-master-local name=sfp1-slave-local
set [ find default-name=sfp2 ] auto-negotiation=no master-port=ether1-master-local name=sfp2-slave-local
set [ find default-name=sfp3 ] auto-negotiation=no master-port=ether1-master-local name=sfp3-slave-local
set [ find default-name=sfp4 ] auto-negotiation=no master-port=ether1-master-local name=sfp4-slave-local
set [ find default-name=sfp5 ] auto-negotiation=no master-port=ether1-master-local name=sfp5-slave-local
set [ find default-name=sfp6 ] auto-negotiation=no master-port=ether1-master-local name=sfp6-slave-local
set [ find default-name=sfp7 ] auto-negotiation=no master-port=ether1-master-local name=sfp7-slave-local
set [ find default-name=sfp8 ] auto-negotiation=no master-port=ether1-master-local name=sfp8-slave-local
set [ find default-name=sfp9 ] auto-negotiation=no master-port=ether1-master-local name=sfp9-slave-local
set [ find default-name=sfp10 ] auto-negotiation=no master-port=ether1-master-local name=sfp10-slave-local
set [ find default-name=sfpplus1 ] auto-negotiation=no master-port=ether1-master-local name=sfpplus1-slave-local
/interface ethernet switch port
set 0 isolation-leakage-profile-override=0
set 1 isolation-leakage-profile-override=0
set 2 isolation-leakage-profile-override=1
set 3 isolation-leakage-profile-override=1
set 4 isolation-leakage-profile-override=1
set 5 isolation-leakage-profile-override=1
set 6 isolation-leakage-profile-override=1
set 7 isolation-leakage-profile-override=1
set 8 isolation-leakage-profile-override=1
set 9 isolation-leakage-profile-override=1
set 10 isolation-leakage-profile-override=1
set 11 isolation-leakage-profile-override=1
/interface ethernet switch port-isolation
add port-profile=1 ports=sfp1-slave-local,sfp2-slave-local type=dst
/ip address
add address=172.16.0.32/24 interface=ether1-master-local network=172.16.0.0
/ip dns
set allow-remote-requests=yes servers=172.16.0.1
/ip route
add distance=1 gateway=172.16.0.1