Community discussions

MikroTik App
 
KBoris
just joined
Topic Author
Posts: 21
Joined: Sun Sep 30, 2012 10:06 pm

hAP lite - "die" after I run script

Thu May 14, 2015 9:38 pm

I unbox my new hAP lite and I upload configuration.rsc file. I start command in terminal window /system reset no-defaults=yes run-after-reset=configuration.rsc. Router reboot and after that access is not possible any more (Winbox does not see router MAC or IP address). If I tray to reset .... nothing happened.....

I try same procedure on next router and I find, if I made firmware upgrade first everything works fine. Router is reachable after I run script . Unfortunately before I find solution I destroy 3 routers. Can I fix them somehow ?

I made a lot of research but can not find proper solution....

Any advice ?
 
KBoris
just joined
Topic Author
Posts: 21
Joined: Sun Sep 30, 2012 10:06 pm

Re: hAP lite - "die" after I run script

Fri May 15, 2015 5:36 pm

.......nobody ????? Procedure how to load default setings ???
 
uldis
MikroTik Support
MikroTik Support
Posts: 3446
Joined: Mon May 31, 2004 2:55 pm

Re: hAP lite - "die" after I run script

Fri May 15, 2015 5:56 pm

please reinstall the hAP lite with the new RouterOS using Netinstall.
Press and hold the reset button and power on the board, keep holding the reset button for approx 10-15 seconds till it goes into the network boot.
Then use Netinstall tool to reinstall it.
http://wiki.mikrotik.com/wiki/Manual:Netinstall

Who is online

Users browsing this forum: abdolali, Ahrefs [Bot], cahensipe, GoogleOther [Bot], svmk and 95 guests