Hi, after i watched your video on youtube on the arp tutorial, because im looking for a Static ARP Table and non-dynamic
https://www.youtube.com/watch?v=Hudi5Ncs8EQ
and here
https://www.youtube.com/watch?v=z3QYRc-ga0U
i openned winbox version 3.37
and i connected directly to my new rb5009 (7.10.2)
and i clicked on interface selected ether8 and change arp mode to Disable,
next i clicked on my Bridge1 on the bridge section on the winbox left menu and also changed arp mode to Disable
i restarted my router,
and to verify everything was correct and working, i opened winbox, go ip/arp
and sadly i found again new dynamic devices with new mac address configured with ip
and i have try to block arp request, in bridge filter arp to drop every arp request in input chain of course
and its not work, and i have asked to chatgpt , no solution
someone have the same issues?
and in case someone ask, no my new rb5009 cannot update to the new 7.11 the router refuse to take it,
and yes i have downloaded the good file arm 64 bit, and i have also selected my model on the hardware page
and loaded the file to the file section (winbox)and rebooted and the file arm64 7.11 are gone but not updated, and i
play with mikrotik router for almost 10 years now, im not new to this mikrotik world, but my issue is the arp.