BGP Manual Refresh

Dear SysAdmins,

We’re looking to hard refresh our BGP session. The command ‘/routing bgp peer refresh’ is a soft reconfigure which isn’t what we’re after. We need the hard BGP refresh. On a cisco router, the command is clear ip bgp IP out

Would anyone know what the equivalent on a mikrotik is? We’re using the CCR1072 with RouterOS 6.47.8

Thanks in advance

Kind Regards

What do you mean by hard refresh. Tear down the session and restart? If so then peer disable/enable.

Hi mrz,

Thanks for the response. Disabled/Enabled the peer, and then rebooted the box and also switched off the CCR completely for 10 mns and powering it back on, but no effect - The routes are still not being advertised :frowning: and yes, they’re added/filtered exactly the same way as all the previous ones.

Kind Regards