Can’t login to web interface on LAN I’m able to login to the web interface on the WAN port just fine, however, on the LAN interface it brings up the login page, but will not access my username and password. I’m using the same user/pass that I can login using the WAN interface. Situation: StarLin…

Hi, This “except” is very important word. Share you configuration to let someone check it /export file=anynameyouwanttaassign remove confidential data before posting it

# 2025-07-28 05:10:27 by RouterOS 7.19.4 # software id = FXXX-XXXX # /interface bridge add name=bridge1 /interface ethernet set [ find default-name=ether3 ] disable-running-check=no name=ether1 set [ find default-name=ether1 ] disable-running-check=no name=ether2 set [ find default-name=ether2 ] dis…

Good Afternoon, I have attempted to replicate your config in our office lab on a hAPac lite and have been successful in accessing WebFig with the default user/password combination, when a direct ethernet connection is established between the PC and physical ports ether2/ether3 (not the reassigned n…

[image] TheBearAK: /interface ethernet set [ find default-name=ether3 ] disable-running-check=no name=ether1 set [ find default-name=ether1 ] disable-running-check=no name=ether2 set [ find default-name=ether2 ] disable-running-check=no name=ether3 Seriously? Interface name shuffling? …

Thanks for the reply. The laptop I'm using as a client side is set up with: 172.16.240.40/24 with a router set to 172.16.240.1. This is a static IP. I try to access using http://172.16.240.1/ It actually brings up the login screen, I'll enter the credentials, and hit login. It will then blank…

Did you try an alternative web browser? Preferably with no extensions installed?

I've tried Safari, Chrome, Firefox and Edge. So yes.

Let's focus on the bridge1 connection for now. Again, I've set up a duplicate config on a hAP ac lite and I have successful WebFig access. Can you confirm that the laptop has a direct ethernet connection to the Ether2 port on the MikroTik? If so, considering that you are connected with a 240.X IP…

Your login works on WAN, so the credentials are fine. Check RouterOS IP service settings to allow HTTP/HTTPS on the LAN IP, and review firewall rules to ensure the 172.16.240.0/24 subnet isn’t blocked.

okay, this was frustrating. I had tried both a Mac and PC to connect directly to ether2 and verified the IP address. Again, it was connecting, but would not accept the password. Like you guys suspected, it really pointed to a problem with the PC/Mac. Since I had tried 4 different browsers on 2 diffe…

Can't login to web interface on LAN

RouterOS General

jaclaz August 13, 2025, 11:49am 17

Just in case: