CAP ac: quick setup as Home AP Dual

RouterOS Beginner Basics
1

Hello,
I managed once to get this Setup working. Later I had to reset the router (5s reset button while booting). And now I can’t get to work the AP mode.
Router OS is 6.41.4. Router is connected via Eth1 to my LAN. Configuring from a PC in the LAN.
Procedure:
Quick Set => “Home AP Dual” (from originally “WISP AP”)
Country => “Germany”
Router obtains IP 172.24.1.37 correctly from the DHCP Server in the LAN
Local Network / IP Adress: 172.24.2.1
DHCP Server On
DHCP Server Range: 172.24.2.10
Then I Click Ok, and after a few seconds Winbox Closes, and the CAP ac ist shown with an IP 0.0.0.0, no more connection possible from the PC until i reset the router.
Any help appreciated
TIA
Michael

2

you can still access it by clicking on the MAC address in winbox

3

Thank You,

I tried, but this did’t work either (PC connected via Switch to eth1).

4

Ether1 is firewalled. Connecting to the device is only possible via Ether2 or WiFi

Ether1 is normally used for the ISP side (QuickSet assumes that).

5

Thank You very much,

now I got the AP working as expected.

Michael