hap ax^2 problem

RouterOS Beginner Basics
1

Hello,
I have bought a C52iG-5HaxD2HaxD-TC mikrotik router. I have upgraded to version 7.13

After installing the wireless package, and selecting System->Reset configuration, everything was gone.

I could only connect to the router by using the MAC address.

I did make a bridge to use all ethernet ports.

However, all configuration for wireless was lost. There is no wifi whatsoever.

I disabled the wireless package and re-enabled wifi-qcom

Now there are the radios but they are completely unconfigured.

I need help (as a newbie) to configure them back with all their options.



Thank you very much
Dan

2

For hAP ax2, you should not use wireless package, instead you need wifi-qcom package (note: not wifi-qcom-ac, just wifi-qcom).

After you install wifi-qcom, reset to defaults again.

3

This reset to defaults should be done from within WinBox ?

4

Whatever way you want but Winbox is the easiest, yes.

5

OK, thanks, This problem is solved

6

Credit to mkx then :sunglasses:

7

I’m shocked, MKX forgot to state after the advice, reset to deafaulst and THEN USE QUICKSET???