Hello everyone,
I have routersos 6.46.3, I want to configure port ether4 when i try to click on (DHCP Setup) it comes message ( interface is slave )
when i try to click on add “+” and add new dhcp server and click on ok comes message ( couldn’t add New DHCP Server-can not run on slave interface )
what is the problem ???
Is your ? key stuck?
Put the server on the bridge or take the port out of the bridge.
Because all ports form 2 to 8 and SFP+ and SFP are slave of a bridge, so you need to setup your dhcp server on bridge interface!
Mine is in bridge mode but I still can’t change the port status from slave
The port is a slave because it is a member of the Bridge. To make it not a slave (of the Bridge), remove the port from the Bridge.
Your firmware is getting dated.