jainge
Big question is that all connection give you the same eNB=Tower what is a confimation that Tower used all that bands.
You can run a cell-monitor from CLI or run from CLI at-chat 0 input=“at+eemginfo?” to see what are Intra and Inter from your Tower to be sure.
When I do not select a specific LTE Band in the LTE Interface, it immediately locks onto B2… which may or may not be the best performing band in the area.
Mostly the connection is base at signal, when you want to force connection to specific tower then Cell Lock is your friend.
And then it does nothing more than stay on B2… Once in awhile, it tries to select B17 or B12 as the CA Band, albeit momentarily.
After a minute or less it simply disconnects from the chosen CA Band and never tries to connect a CA again, however, B2 stays connected.
Good way is enable a monitoring of change at not only bands but sector antenna you are connected to be aware of that changes, check
Watch LTE parameters: http://forum.mikrotik.com/t/sxt-lte-4g-cat6/134468/1
I’m guessing that I’m not setting this up properly or I’m not selecting something properly…?
Rather that, module just be hop between bands and antennas to found most stable connection.
I have tried different variations of selecting all GSM, 3G and LTE, selecting 3G and LTE, and I have tried just selecting LTE.
As for the LTE Bands, am I supposed to tick off (select) ALL of the LTE Bands that I wish to possibly connect to (in this case B2, B12 and B17)?
Or, am I only supposed to select the Primary CA LTE B2 and let the R11e-LTE6 modem negotiate the CA with another channel on it’s own?
Always the scanning using cell-monitor to detect all earfcn & phy-cell-id and do at+eemginfo and CellLock to test all them, that way you discover what specific tower give band/speed.
CA is automatically assigned.