Need guidance to configure router hAp ax2

RouterOS Beginner Basics
1

Hello everybody.

I do not have much knowledge about networks (I’m a mobile developer) and recently (last month) I bought a router (Mikrotik hAP ax2), but I’m having difficulties to configure it.

My idea for organizing my network is:

  1. Blue Zone (example DHCP range 192.168.10.1 - 50):
    → eth[2..5] + 5GHz wifi for personal use with access to the Raspberry Pi (which contains servers) and a NAS
    → The consoles (ps and xbox) on this network (NAT available)
    → SSH/VPN access
    → eth1 is WAN port (port to connect to ISP router)

  2. Red Zone (example DHCP range 192.168.20.1 - 50):
    → only wifi, separated from the blue zone (no access to servers), only access the internet. This network is for guests.


    In both zones, they only access the PiHole/Adguard DNS, firewall is activated. I’ve lost count of the time I reset the router’s settings trying to configure the network. I followed (that is, read and tried to understand) the example available at (http://forum.mikrotik.com/t/using-routeros-to-vlan-your-network/126489/1 → post RouterSwitchAP), but still without success.


    Can anyone guide me in configuring the equipment?

Thanks in advance.
Mike


PS: Sorry for my english (is not my native language), so I tryed write correctly

2
  1. Use safe mode when configuring
  2. Use a port (take it off the bridge ) to do the initial configuring much easier.
  3. Use one bridge and vlans
  4. Dont use Capsman just becuase its available, if you introduce other MT wifi access points later consider it then.

2 → https://forum.mikrotik.com/viewtopic.php?t=181718
3–>http://forum.mikrotik.com/t/using-routeros-to-vlan-your-network/126489/1