Power Break during Upgrade

medube · April 21, 2006, 9:00am

Hi,

I was recently upgrading my RB532 and had a power break in the middle. Since it came back up, I cannot seem to have any communication with the borad. Though it powers up as normal but I cant seem to have any contact with it.

Is there anything I can do, please help…

VicNet · April 21, 2006, 9:31am

Very bad,

Your board is broken.

Please contact with your board suppiler mayeby they can help you.

medube · April 21, 2006, 9:33am

Ok. If I slot in a CF card will it override the onboard memory and load from CF?

normis · April 21, 2006, 9:33am

how about output from serial console?

medube · April 21, 2006, 9:34am

Hi I tried to see it thru serial, I get Loading fro Nand OK and then it goes System Halted.

normis · April 21, 2006, 9:40am

try to reinstall RouterOS with netinstall:
http://www.mikrotik.com/docs/ros/2.9/guide/netinstall

medube · April 21, 2006, 10:51am

Thank you Normis, so far I have been able to install using netinstall. After the first reboot it goes thru all the normal bootup process, but then just stops on Starting Services…

Is there anything else I must do?

Thanks again

cmit · April 21, 2006, 10:52am

Try changing your baudrate. Sounds like the console could be configured to use another baud rate…

Best regards,
Christian Meis

medube · April 21, 2006, 11:01am

Thank you guys, it worked out well. I really appreciate the assisstance and suggestions.

Thanks again